- News & Media
DGAP-News: Nordex SE / Key word(s): Product Launch
- Maximum efficiency thanks to more than 20,000m² swept area
Hamburg, 14 August 2019 The Nordex Group is further extending its product portfolio in the market segment of turbines with a nominal capacity of more than 5 MW. "At the heart of our product development strategy, is the continued expansion of the capabilities of our proven Delta4000 platform. We have now reached a further milestone with the introduction of the N163/5.X," says José Luis Blanco, the Nordex Group CEO. The N163/5.X turbine will be presented at the German Husum Wind Fair, which takes place from 10 - 13 September 2019.
Compared to the recently launched N149/5.X turbine, the N163/5.X shows its strengths particularly on projects with lower wind speeds. The nacelle, gearbox and all system components of the N163/5.X have been taken over from the N149/5.X. A new element is the single-piece rotor blade, with a length of nearly 80 metres, based on the proven and tested glass fibre/carbon fibre differential construction concept of the N149, which Nordex has been using in serial production for its blades since 2011. The rotor diameter has been increased by 14 metres to a total of 163 metres compared to that of the N149/5.X. This makes it one of the biggest rotors in the onshore segment. This larger rotor diameter results in a swept area of 20.867 square metres. Compared to the N149/4.0-4.5, currently being produced in series, this means an additional yield of up to 20 percent for the new turbine.
The N163/5.X is designed for maximum flexibility and can be operated in different modes in the 5 MW range depending on site requirements and customer needs. This enables customers to individually configure the wind farm with regards to energy yield, turbine lifetime, rating and sound requirements, and thus adapt it ideally to the specific business model. The N163/5.X continues the successful approach of a flexible power range of the Delta4000 turbines N149/4.0-4.5 and N149/5.X.
The turbine will initially be offered with hub heights of between 118 and 164 metres. The turbine options also include a cold climate version for operation in temperatures as low as -30 C. The start of the series production of the N163/5.X is scheduled for 2021.
The Delta4000 series at a glance:
Turbines in the 4 MW segment:
The Nordex Group at Husum Wind 2019: Hall 1, stand no. B11
For more information, please contact:
Contact for investors:
14.08.2019 Dissemination of a Corporate News, transmitted by DGAP - a service of EQS Group AG.
|Phone:||+49 381 6663 3300|
|Fax:||+49 381 6663 3339|
|Listed:||Regulated Market in Frankfurt (Prime Standard); Regulated Unofficial Market in Berlin, Dusseldorf, Hamburg, Hanover, Munich, Stuttgart, Tradegate Exchange|
|EQS News ID:||856895|
|End of News||DGAP News Service|